Dear All,If we configure a Voice and Data VLAn on a switch. And connect EX90 on voice VLAN and PCwith EX90 terminals. Than can we able to share a presenstation or data with EX90 or not?Best Regards,AR

Dear all,Is it possible that we can create a agent and use the cisco IP communicatore and hard IP phone at same time for that agent. These two phones will work as a backup. If hard phone goes down it will automatically switch to soft phone and vice v...

Dear all,Currently we have a CUCM installed at head office and we have one PBX at head office and othe is at branch office. These are tradiditional PBX's and doesn't support E1. Now I want to conect these PBX's with voice gateways on trunk ports and ...

Dear all,I have installed a PRI on a voice gateway router. I made the following configurations on a router to route the incoming calls towards IP Phone users.card type e1 0 0network-clock-participate wic 0 network-clock-select 1 E1 0/0/0controller E1...

Hi all,Voice ports are not showing for the HWIC-2CE1T1-PRI cards whereas voice ports are showing for FXO cards. Please find the below outputs. What is the problem and how I could enable voice ports for this?sh inventoryNAME: "CISCO2921/K9 chassis", D...