Dan Smith
Level 1
Level 1
Member since ‎06-13-2013
‎06-21-2019

User Statistics

  • 8 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received

User Activity

Hi all, I have HSRP running on a VLAN and also DHCP issuing the default gateway as the standby ip address.  Basic security measure of HSRP authentication is enabled too so no one can hijack the HSRP session unless (the obvious) someone guesses/breaks...
Hi all,Potentially a 'shoot in the foot' question, but in all honesty; I don't know... How do ISPs rate limit their customers?  I.E. 10Mbps download, 2 Mbps upload?! So, my scenario; I am essentially in control of a network where I will be a Service ...
Hi all, I wonder if anyone can offer any suggestions/hints regarding my dilemma...We are about to have 2x point-to-point fiber links installed between our sites.  My colleague is looking at a MUX solution so that Ethernet, E1 and RS232 can be directl...
I have 2 systems in different locations sending to the multicast address 239.192.201.19 on port 55304 - I have been tasked with sending both of these feeds into another system for analysis.  So immediately you can see the problem. After some googlein...
Hi all,Regularly getting the following error appear in my logs and looking for some suggestions: %MV64340_ETHERNET-5-TOOBIG:  GigabitEthernet0/0, Tx pak is too big, 2998 bytes So, interface G0/0 is configured as a 'Trunk' and the default MTU is set.A...
Community Statistics
Member Since ‎06-13-2013 06:34 AM
Date Last Visited ‎06-21-2019 01:02 AM
Posts 8