About John McNumara

John McNumara · 09-18-2014

Hello, Suppose I had the following configuration in an IOS router interface <interface type/number> ip address 1.1.1.3 255.255.255.0 secondary ip address 1.1.1.2 255.255.255.0 ip route 0.0.0.0 0.0.0.0 1.1.1.1 access-list standard INTERNET_BOUND_ACL p...

John McNumara · 03-03-2014

Hello,I have a Catalyst 3650 operating as a Mobility Controller. I had to change the interfaces on the 3650 that connected to the access points to explicit access ports (switchport mode access). Before that command was configured, the APs sparatica...

John McNumara · 01-05-2014

Topology:Hub:(hub lan: 10.0.1.0/24) > (lan int [ip nat inside], g0/0: 10.0.1.1) > (flex interface, loopback100: 172.31.100.1) > (flex virtual interface, Virtual-Template1: ip unnumbered loopback100) > (wan int [ip nat outside], dialer0 - g0/1) > ISPS...

John McNumara · 12-21-2013

Config:Hub:interface Virtual-Template1 type tunneldescription FlexVPN hub-to-spokesip unnumbered Loopback100ip mtu 1400ip nhrp network-id 1ip nhrp redirectip tcp adjust-mss 1360tunnel path-mtu-discoverytunnel protection ipsec profile defaultSpokes:in...

John McNumara · 12-19-2013

We have two buildings 300 feet apart with perfect line of sight. Price aside, what is the best point-to-point wireless bridge avalable from Cisco at this time? 54 Mbps max with 802.11a on a 1400 series wireless bridge is nowhere near acceptable for ...

John McNumara · 03-03-2014

Stephen,Is there an alternative to the 3650/3850 series switches I can use as a Mobility Agent? As I am only needing to terminate 2 CAPWAP tunnels, can I use something like a 2504 as a Mobility Agent? If not, is there another series that is less ex...

John McNumara · 03-03-2014

Nevermind, I unfortunately found my answer: http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3850-series-switches/qa_c67-722110.html

John McNumara · 03-03-2014

Stephen,Thanks for the quick reply. Unfortunately, the 3650 is the only WLC in the building, which spans well over 300 feet in either direction to the APs. We positioned the 3650 to where we are only leaving a few APs not directly connected as they...

John McNumara · 01-10-2014

I have been on vacation and my team just rolled back to DMVPN. I am going to have a similar project within a month or so, and will try the exact same settings to see if this fixes it and let you know.Thanks again!

John McNumara · 01-06-2014

We've been working with these confs for a while, so they aren't as clean as they could be, but here they are----------------HUB----------------version 15.2service tcp-keepalives-inservice tcp-keepalives-outservice timestamps debug datetime msecservic...

Member Since	‎05-20-2013 11:38 AM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	43

User Statistics

User Activity

Changed source address based on destination IP

Catalyst 3650 as MC with non-directly connected APs

FlexVPN Cannot Ping From Spoke LAN only

FlexVPN Spoke to Spoke issues

High performance wireless bridge

Catalyst 3650 as MC with non-directly connected APs

Catalyst 3650 as MC with non-directly connected APs

Catalyst 3650 as MC with non-directly connected APs

FlexVPN Cannot Ping From Spoke LAN only

Re: FlexVPN Cannot Ping From Spoke LAN only