About Tomasz Hinz

Tomasz Hinz · 12-15-2017

TPL(config-if)# switchport ? access Set access mode characteristics of the interface autostate Incl...

Tomasz Hinz · 12-14-2017

Because I have confirmation from other source about that, now I'm sure that is not possible. Many th...

Tomasz Hinz · 12-13-2017

Hello there, On nexus 3064 I can do Q-in-Q with following config: nterface g0/10 switchport switchpo...

Tomasz Hinz · 10-29-2017

Dear All. On Cisco routers and switches with classic IOS we had ip ssh rotary command to change defa...

Tomasz Hinz · 08-30-2017

Dear all.Can you recommend a router / switch that would meet the following requirements?IPV4 prefixe...

Tomasz Hinz · 01-25-2016

I have problem with Nexus 3064. I would like to send statically multicast to Cisco 3550 switch. I co...

Tomasz Hinz · 06-24-2015

I've problem to send special characters to E1 port of Cisco Voice router Cisco 2911. I made dial-pee...

Tomasz Hinz · 06-22-2015

I've problem to send special characters to E1 port of Cisco Voice router Cisco 2911. I made dial-pee...

Tomasz Hinz · 06-01-2015

I've problem with call transfer between fxs ports, when i run debug vpm singnaling I receive that de...

Tomasz Hinz · 05-30-2015

Actually does not configure any signaling yet. I try check the device and mentioned call transfer be...

Tomasz Hinz · 05-30-2015

Hello.I've problem during IAD2430 configuration. I configured device with his internal numbers, but ...

Tomasz Hinz · 03-02-2015

I've problem to set BACD on my Cisco3945E, after whole day working on it I've no idea what happen. A...

Tomasz Hinz · 02-01-2015

Hello.I have a problem that I have a small branch with ASA-5505 using the VPN connects to two branch...

Tomasz Hinz · 01-13-2015

Hello. I've question about cisco 7600. I've 7600 with SIP-400 and 2xWS-X6748-SFP, I want use PPPOE t...

Tomasz Hinz · 10-08-2014

Thank you for your responseCisco works only as "Media converter" , all phones are connected to Altel...

Re: Nexus 3064 many Q-in-Q tunnels on interface