michaelngai

michaelngai · 04-28-2014

Hi All,Seeking a bit of advice here.Have a requirement to design a flat L2 network for a small manuf...

michaelngai · 08-17-2013

Hi Brian, sorry previous output I didn't fully enable SIP. URL command does exist and after drilling...

michaelngai · 08-15-2013

Hi Jonathan, thank you for the response. I've tried that but there's no such commands under "voice r...

michaelngai · 08-15-2013

Yes that thread answered my question perfectly. Thanks.

michaelngai · 08-13-2013

Hi All,Anyone know if the below command has a SIP equivalent?telephony-serviceurl idle http://XXX/id...

michaelngai · 08-12-2013

Thank you Karthik for the response. Yes strangely it worked, I had always though anything under "tel...

michaelngai · 08-11-2013

Sorry to bring up an old post. Abdulateef, have you got any update to this? I'm wondering exactly th...

michaelngai · 08-11-2013

Thanks for the link Jorge. I tried it and it was no good either. I did try configuring CME from scra...

michaelngai · 08-10-2013

Hi All,Can't figure this one out for a while. How do you put a SIP endpoint namely the 9971 into pow...

michaelngai · 07-28-2013

Thank you Jorge for chasing this one up. Interesting Jabber for Android is still not listed for CME ...

michaelngai · 06-13-2013

Hi Jorge,In the below document it seemed to suggest otherwise? Which one is correct? Are you able to...

michaelngai · 06-13-2013

Thanks for taking the time to document this. Any pointers as to where troubleshooting can begin if i...

michaelngai · 06-13-2013

Sorry for bringing up an old post. Did you have any luck resolving your issue? I have similar proble...

michaelngai · 04-04-2013

Works!! Thanks.

michaelngai · 04-04-2013

Thanks leolaohoo.Trying to get an "out of the box" router to load bootstrap so it'll pull the full C...

How to design for physical layer redundancy