Hi, we have a stack of 2 x WS-C3750X-48P switches with a 10 gigabit module in each: When I run a show inventory I can see everything except for the LRM SFP within the 10 gigabit module in the second stack member. See below:
#sh verCisco IOS Software...
Hello, I support an active VSS cluster using 2 x 6509E chassis with single Supervisor 3C modules in each chassis. I want to replace these with Supervisor 2T modules. All my service modules and line cards are supported with the Sup2...
Assuming you have checked everything in this thread already, are you sure you are not maxing out your router's capacity?
Check this out:
https://supportforums.cisco.com/discussion/11418111/throughput-cisco-2911-2921-2951
--Tim
Hi, originally it was but the switches have been power reset on a number of occasions since.
Please note the SFP is working fine, we just can't see it in "show inventory" and thus we can't see the serial number for maintenance purposes.
Hi, this is a cosmetic error. The SFP is working and is actively a part of the etherchannel. I just can't see the SFP when I run a "show inventory". So, I believe it to be a cosmetic bug
Just to close off this unanswered question, you can get into that state (FSM_FT_STATE_STANDBY_COLD) if you have an active and standby ACE and you upload a new cert and/or key and forget to import the cert and/or key to the standby ACE. Then if you sa...
