Laszlo Zoltan
Beginner
Beginner
Member since ‎11-05-2001
‎04-20-2022

User Statistics

  • 38 Posts
  • 2 Solutions
  • 20 Helpful votes Given
  • 20 Helpful votes Received
Recent Badges
10 Helpful Vote
20 Replies
1 Accepted Solution
1 Helpful Vote
10 Replies
5 Replies

User Activity

Hi all,I have a multicast network like this:      +-----+      | SRC |      +--+--+         |----+----+----+----    |         |    ~         ~    |         | +--+--+   +--+--+ | R1  +---+ R2  | +--+--+   +--+--+    |         | +--+--+   +--+--+ | RCV...
Our multicast service provider need IGMP join packet in order to send the multicast traffic. The service provider does not support PIM routing. We have a Cisco 4500X switch between the multicast service provider and the multicast receiver. If I set o...
There are two multicast routers receiving same multicast stream from two inbound links. The routers have to select one stream and to forward it to an output interface. There is a problem if the router sends back the incoming stream to the other inbou...
I cannot find in the data sheet of C881-V that the BRI interface could be used as ISDN network side function or not.Can I set these parameters?!interface BRIx isdn switch-type basic-net3 isdn protocol-emulate network isdn layer1-emulate network!Thank...
One of our customer has an UC520 system with SWP 7.0.2. They want to use new SPA303 phone but this version of sw does not support this type of phone.I read in the document of “UC 500 Software Packs” (https://supportforums.cisco.com/docs/DOC-9827) tha...
Community Statistics
Member Since ‎11-05-2001 03:04 AM
Date Last Visited ‎04-20-2022 12:20 AM
Posts 38
Total Helpful Votes Received 20
Helpful Votes From
Helpful Votes Given To