Nowadays with a limited number of IPv4 addresses using PAT is very common. Many hosts on our internal network hiding behind a public address. Have you ever wondered how the table is very common when using PAT, and what's possible for us to retrace AS...
To understand how the inspection icmp error should first understand how the default ASA acts upon receipt of the ICMP packet.All examples are based on the topology:Basic configuration:################R1###############!interface Loopback0ip address 13...
Dynamic L2LDynamic crypto maps gives us the opportunity to create a L2L tunnels where the remote peer's address is unknown.The ASA configuration we have built a group called DefaultL2LGroup. If you do not configure any other matchowania to tunnel-gro...
Hi Adam,Sorry for my late responce I am a bit ill.I have checked the logs and did small repro. To me it looks like the server is not supporting NEM: This is from VPN server with NEM disabled:Nov 30 00:13:56 [IKEv1 DEBUG]: Group = gsa3mle3, Username =...
Hi Adam,It looks strange you didn't match iskmp policies but the phase1 was compleated.Could you attach the logs from:#debug crypto isakmp packet #debug crypto isakmp detailKind regadrsMichal
Hi Adam,Sorry for my late response.I can see that default route is via fa0/0 interface and it is also your “inside” interface :interface FastEthernet0/0crypto ipsec client ezvpn mle3gsa insideI understand that you are accessing your peer A.B.C.D via...
Hi Adam,You applied it to lo0 interface. Is it yours outging interface? And workstations are behind fa0/0?Could you pleae provide sh ip route output.Kind regardsMichal
Hi Rudy,That is why most likely he won't be able to set up L2L tunnel.With Cisco EzVPN client on IOS, you can choose the mode (in this case I would try NEM) and also you can specify acl for SA establishment (also could be tried in this example).Kind ...
