CLIA ver 3.5.1 against a few different ASAs, with the latest interim ASA IOS to mitigate the latest SSH/VP/XML vulnerability.   We run System Diagnostics and it appears to process - and has worked previously on different ASA's - but now [today] gives...

Can't pin this one down.  uc560, Running: software pack 8.02 - CME 8, CUE 8.06 - yes, I know its old.We added a new 7975, it would not register, discovered that the term75.default.load  file had bad info in it and the tftp lines for the 7975 were als...

Hi all,New out of the carboard box non-production UC560 t1e1, set back to factory defaults using cca 3.1.1 while performing the 8.2 software pack upgrade.  Two 7962+7915 operator phones, then all 525G2's, one 7937 Conf phone, using esw520-24P switch....

We are looking to deploy an AP541 with a Cisco Unified IP Phone Power Injector (CP-PWR-INJ=) to create a WiFi network for a customer, but want to know what else we need to have in place in order to allow simultaneous secure access to the corp. lan an...

All,I found this below here: http://www.apcmedia.com/salestools/TDOY-5UQVE5_R8_EN.pdfYou need APC part # AP9840Connect this cable to the APC UPS and the console port on the UC500's.Add CLI code to supoprt graceful shutdownline aux 0privelege level 15...