About Jarrett Cadiz

Jarrett Cadiz · 09-12-2012

Hi Everyone,I searched on Google for this unique behavior I discovered on a pair of SG300-28P.On a second switch (ver 1.2.7.76) when I unplugged the power cord, to my amazement the switch turned right back on (about 1 second later), with the power co...

Jarrett Cadiz · 02-06-2012

Hi Everyone,I have been learning a lot about Cisco switches and I had one setup with a few vlans (10,20,70). Recently I enabled inter-vlan routing on the switch and everything seemed to be going ok, and then suddenly file transfer rates between compu...

Jarrett Cadiz · 09-27-2012

Hi Dimitri,We never did find a solution to this problem on the Cisco small business switches. Eventually we upgraded them all to the Cisco Catalyst 3750x and 3560x switches and these problems are not existant on the new switches. It may be some kind ...

Jarrett Cadiz · 09-13-2012

Hi Thomas, Thank you for your response, here is a small diagram of the connection between the two switches.[GBE 3-1– SG-300-28P] | - From Ports 1, 4, 5, 7, 8, 11, 16 | | - (Trunk) | - To Ports 1-4, 16-18[GBE 4-1– SG-300-28P]The s...

Jarrett Cadiz · 02-07-2012

Hi Dan and Glen,Thank you so much for replying to me. I did change the routing mtu back to default, however with it only switching I still found it going much slower than wire speed.It later was discovered that a downstream switch (esw-540-24p) does...

Member Since	‎02-06-2012 03:11 AM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

SG300 Stacking and Powered from POE by Upstream Switch

Slow InterVlan Routing Cisco 3560x

Switch refuses EAP Certificate Authentication

Re: SG300 Stacking and Powered from POE by Upstream Switch

Slow InterVlan Routing Cisco 3560x