Noticed that a point to point OC3 circuit has a steady output drops without any other errors or bandwidth issues. thoughts?POS1/0 is up, line protocol is up Hardware is Packet over Sonet Internet address is 10.20.54.1/29 MTU 4470 bytes, BW 1550...
Is it possible to have or setup VPC on an ASA? even if you are doing routing on the ASA? i was looking through:http://www.cisco.com/en/US/docs/switches/datacenter/sw/design/vpc_design/vpc_best_practices_design_guide.pdfanyone that has some experien...
Hi Everyone, I wanted to ask if QoS is required on a PRI circuit? the scenario is that SIP will be coming to the building but, it will be converted to PRI. therefore, it will not be on our MPLS cloud. Therefore, i am trying to find a definit...
All, I wanted to verify that i could create a VACL to compensate for the session limitation of "2" to create both an RSPAN and regular SPAN. if someone could confirm that would be great.
All, i was able to setup split tunneling and phase 1 is successful however, i am unable to ping any subnet that is being NAT. therefore, trying to figure out how do i allow any VPN connection with a 192.168.20.X address can ping i.e 192.168.10.X.
i heard that when and if dynamic routing is happening then it will create an issue. this is why i am a bit confuse as everything seems to say that you can.