Looking for advice on the following:
Primary site with WAN connectivity to all offices through 3rd party WAN provider.
Backup site has failover WAN connectivity to all offices through 3rd party WAN provider.
100MB P2P link in place between primary ...
Hi all,
I'm looking for help in configuring a 4351 ISR to run a L3 router and provide PoE to IP & 2702i AP's using the UCS-E SM.
ISR 4351: ISR4351/K9 running IOS XE 03.15.01c.S
PoE Switch: SM-X-ES3-24-P runing 15.0(2)EJ
UCS: UCS-EN120S-M2/K9
I ha...
Maybe you've fixed this but have you tried this command from router prompt: hw session 1/0
This connects a terminal session (similar to console cable) to the switch module.
You should then see the switch prompt & configure from there.
To exit back t...
So having worked through all three vendors (Cisco, EMC & HP) I tested the passive Twin-Ax cables SFP-H10GB-CU3M-C(non-branded) from my WS-C4500X directly into a dual port HP NC552 SFP adapter. These all worked without issue.
Hi oquarisco,I've not tried the 4500E Sup7 connections, so cannot help there.However I have connected a WS-C4500X-16 running 15.0(1r) SG and 03.04.00.SG into HP DL360 Gen8 servers using the following:4500X:SFP-H10GB-CU3MHP DL360:NC552 SFP 10GB 2-port...
Had the same problem with my hosted ASA and a mail relay sitting behind it. Disabling the ESMTP policy resolved the problem as the "allow-tls" command was "dated" according to my hosted provider.
I've purchased a SFP-H10GB-CU3M (non-branded) TwinAx cable and have successfully connected from a HP NC552SFP 10Gb 2-port adapter (HP DL360p Gen8) into a 3750X (WS-C3750X-24T-S) 10GB (C3KX-NM-10G) module.Once I receive my 4500X-16SFP switch, I hope ...
