Steven Holl

I just had this issue on my Mac with a DX80 as a second display. I have a 2017 Macbook with Thunderb...

Marwan, I never built in support for a secondary CME server--it only looks for and grabs the primary...

adventerprisek9 is the feature set, and doesn't refer to a version.I tested this on multiple phone t...

Leonardo: Glad the script worked for you.To add another phone, you will need to manually configure t...

I wrote a TCL script to completely automate the secure CME configuration. The configuration of secur...

Yes, you can redirect any show output to ftp/flash/etc with the '| redirect' parameter.I'd recommend...

Debugs show the issue is on CUE--it is returning a 486 Busy.Direct troubleshooting to CUE. Can you d...

There is an option in the FXO port of the MGCP gateway called "ATTENDANT DN*" which does the job muc...

I need more than just a snip of a single message for an analysis. A single ACK isn't sufficient to l...

Yeah that look like it is it; I must hae been mixing it up with the feature to match inbound dial-pe...

Ah, so you just want to restrict VoIP calls from L3 addresses other than your provider?That's just a...

I edited the link; it should work now.kalbasha0 wrote:Q is this a correct statement The main reason ...

giordano_p wrote:Even if your CME uses SIP, try to add these commands under "voice service voip":no ...

mrdogantr wrote:Hi, Yu can use sip and h323 on AS5350.http://www.cisco.com/en/US/docs/routers/access...

You want to reject specific calls? You won't use an ACL for that, since it needs to be done at the v...