Hi, I've noticed some differences for the Cisco 6524 (IOS 12.2(18)ZU2): 1) the "Break sequence" begins when I see this message "Cat6k-MSFC2A platform with 524288 Kbytes of main memory", so after the message "%OIR-6-CONSOLE: Changing console ownership to route processor"" 2) the break sequence is "Ctrl+Alt+Break" but I don't know if this break-sequence is due to my tool that is Putty That's all. Thanks antonio ... View more

Hi, I have the same problem as posted by CamAdam. I haven't an active maintenance so I have to order aa new fan for my Cisco router 3725. I don't find the product code on Cisco website. Anyone knows what is the product code? thanks antonio ... View more

Relating to RAM upgrade, do you know what version of ROMMON do I have to buy to work with 256Mb RAM? MEM2600XM-128DBOT= or BOOT-2600XM-256= I dont' understand if i can buy: - n.1 MEM2600XM-128DBOT= and n. 1 MEM2600XM-128D= or - n.2 MEM2600XM-128D= and n.1 BOOT-2600XM-256= Thanks Antonio ... View more

Now it's ok. I have configured the voice port in loop start with the command "connection plar opx" and I have deleted the command "caller-id enable ". Thanks Antonio ... View more

Hi, I am located in Italy. Actually I have configured the FXO port for ground start and the phone number associated with the FXO port is configured directly on the IP phone. These are the some configuration's details: - voice port voice-port 0/3/2 signal groundStart cptone IT impedance complex2 description mysociety_tel incoming alerting ring-only caller-id enable - Two outbound dial peer associated with the voice port 0/3/2 dial-peer voice 7 pots destination-pattern 0.T port 0/3/2 forward-digits all exit dial-peer voice 8 pots destination-pattern 3.T port 0/3/2 forward-digits all exit - ephone ephone-dn 2 number xxxxxxx name mysociety_tel ephone 12 keypad-normalize mac-address xxxx.xxxx.xxxx type 7911 button 1:2 ... View more