I would like to see a filter by product ID under assets and coverage. I'm attempting to filter out hardware I don't care about (3560 desktop switches) that are EoL and only see our network closet switches by model type. I have only been able to do th...
Does anyone know when or if a Prime 3.7 maintenance release will be out? I'm wanting to be able to add our 9800 WLCs running 16.12s, but have been burned by running bleeding edge Prime releases without maintenance packs. -Kevin
Our 9800-L-F WLCs arrived and I went through the basic CLI wizard to get an IP on one of the interfaces. I chose Te0/1/0 and after getting a default gateway could ping the WLC. I then went to the webserver and was greeted by a redirect to a /dayzer...
I'm looking to upgrade our Prime 3.4 running on a Gen 2 appliance next week. I normally like to upgrade when an MR is also out. Does anyone know if 3.6 will have an MR soon or early impressions on its stability compared to 3.5? We manage wired and...
What is the best code to use on older 3750v2 and 3750e switches? I noticed Cisco seems to recommend 12.2.55(SE11). Is there any benefit to running 15.0.2(SE11)? I don't want to hit memory or CPU issues, which I did read about on early version of 1...
This was an issue I had last year so I’m going off memory. I do not use SVIs on my 9k WLCs for the WLAN interfaces so you are correct in your thinking. I believe I had a DHCP option statement that was causing problems IIRC.
I did have an option statement in there, which I believe was adding the option 82 on the relay as it went to the connected switch. We are connecting our 9800 to a 6807 switch and I also noticed that you can add the command “ip dhcp relay information ...
I agree, but I’ve found the docs here fairly useful. https://www.cisco.com/c/en/us/support/wireless/catalyst-9800-series-wireless-controllers/products-configuration-examples-list.htmlAny specific questions feel free to ask in the forums. Once you get...
I'm also having an issue with a new 9800-L not passing DHCP requests properly. I'm sure it's a config issue. On AireOS the relay/proxy setup was all in the interface settings. You could have it source DHCP requests or ignore and send the requests ...
