What are the things that we should watch out for when migrating from UCS Central to Intersight using IMM Transition tool? What happens to UCS Central or UCSM after the transition? Can it still be used? What happens when the tool fails?
For UCSX 9508, can Fabric Interconnect 6454 be in UMM mode or does it need to be in IMM mode? Can it use both 9508 and 5108 at the same time to support M5, M6, and M7?
How many cable connections should there be when connecting Fabric Interconnect 6454 to 9508 and 5108 at 100GB?
What about connecting just Fabric Interconnect 6454 to 5108 at 100GB? How many cables should there be?
What determines the number of cable...
We have two sites that we would like to send all mirrored traffic to one of the port on site1 for traffic analysis and monitoring using SPAN and ERSPAN. SPAN for Site1 and ERSPAN for Site 2. These core switches are running Catalyst 9400 series.
See...
Sample Diagram here.
The dual ISPs network that I am working has an interesting setup.
In Router 1, here is a partial config
ip route 67.29.128.153 255.255.255.255 50.50.50.2
partial show ip route
Gateway of last resort is 67.29.128.153 to netwo...
Thank you for the quick response! Putting the domain in IMM mode requires decommission and erase everything including fabric interconnect and reconfigure correct? If there is only one existing domain with a pair of FI 6454 and 5108, if the goal is to...
Looks like using 100GB ports on the uplink ports as connection towards the IFM on the 9508 is not supported , correct? There is also no breakout cables possible when connecting the IFMs at 100G toward 4 - 25G ports on the 6454 correct?Basically I hav...
Thank you for the quick reply, BB. SPAN and ERSPAN destination for Site1 and ERSPAN source for Site 2. I believe SPAN and ERSPAN cannot be configured to the same destination port. Instead, I was thinking configure both ERSPAN source and ERSPAN des...
Got it. Thank you for the explanation.
There were some errors in the diagram. Here is an updated diagram. I remove the switches to simplify the diagram. Both Router1 and Router2 are in AS 400. However, they do not have each other as BGP neighbo...