About nh6we

nh6we · 12-29-2020

I am trying to setup my 9130AXE for wireless survey work. In the past it was easy to setup the AP for autonomous mode and you were done. Now with the 9130 I believe there are multiple steps. I was able to convert my 9130 to run as a embedded wirel...

nh6we · 07-19-2016

I have a 3702 access point which is up and running on a 5508 controller running 8.0.121.x code. The site has Cisco Prime (2.2) running. Prime sees all of the other 3702 access points but one. When you check the controller the one problem access po...

nh6we · 03-09-2016

Can any one recommend a free SNMP walk utility

nh6we · 12-07-2015

I am running a 2504 wireless controller using 8.0.120 code. Can some point me to where I would enable channel bonding and band select. Thanks Chris

nh6we · 11-23-2015

Can someone point me to a list of IOS CLI lightweight access point commands. Thanks

nh6we · 12-07-2015

Thanks Chris

nh6we · 11-20-2015

Leo, Thanks for the help Chris

nh6we · 11-20-2015

So will that command set it back to factory - as it was out of the box??

nh6we · 11-07-2015

Will this overwrite the config of the destination access point or just append to its conf file. Thanks for the help

nh6we · 11-02-2015

Thank you for your help. Your sugguestions did the trick Thanks

Member Since	‎05-07-2008 08:59 AM
Date Last Visited	‎01-05-2021 06:45 PM
Posts	67

User Statistics

User Activity

Converting a 9130 AP for wireless survey

Access Point not showing up in Cisco Prime

SNMP walk utility

Enabling 40 or 80 MHz channel bonding

List of Lightweight Access Point Commands - IOS based

Thanks Chris

Leo,

So will that command set it

Will this overwrite the

Thank you for your help.