About Joseph Razionale

Joseph Razionale · 10-09-2013

Hi.The MWR2900 router has a known bug for Marvel chip, which causes the CPU utilization to spike.https://tools.cisco.com/bugsearch/bug/CSCtz75800The workaround is the command "clear mac-address-table secure"I've written the following EEM applet to is...

Joseph Razionale · 10-10-2013

Thanks for the input, Joseph.I'll give it a try.

Joseph Razionale · 10-10-2013

Joseph, Upon further thought, there may be another solution.Is it possible to add a condition before executing any of the "action" statements?This script should only run if CPU utilization is high (above 75%).This might prevent multiple triggers of ...

Joseph Razionale · 10-09-2013

Joseph, I'm hoping to trigger on that exact syslog pattern. I'm trying to prevent multiple executions of the script.Joe

Joseph Razionale · 07-02-2012

AIS (Alarm Indication Signal) is a "all-ones" signal indicating a disruption of incoming T1 signal.Remote alarm, often referred to as "yellow alarm", is sent in the opposite direction of AIS.A device receiving AIS will transmit a yellow alarm back o...

Joseph Razionale · 02-16-2012

Hi, The provided router log is reporting a Loss Of Signal (LOS) on the T1 controller."show log | i T1"Configure "loop-detect" under the T1 controller, and request that the provider intrusively test the T1 facility during off-hours, specifically when...

Member Since	‎02-16-2012 08:10 AM
Date Last Visited	‎09-05-2018 12:26 AM
Posts	6

User Statistics

User Activity

Trigger on syslog on hourly occurrence

Trigger on syslog on hourly occurrence

Trigger on syslog on hourly occurrence

Trigger on syslog on hourly occurrence

AIS vs Remote Alarm Question

Cisco 2851 crashes every night. Help!