Adam, Below is the error I was given :IP Removed:NP_500:Unable to push configuration to device ip IP Removed:FAILURE : [QoS configuration failed while pushing a CLI to the device: <![CDATA[%Tunnel1 used by PIM for Registering, configuration not allow...
That's what I thought should happen. I'm running 1.5.1.1054. When I reapplied the policy, all the switches that were green and had the policy applied have now errored out and are red. I am going to upgrade to 1.6.x and see if that doesn't fix this is...
Adam,Thank you for the response. I believe I could do that, but the problem is that I've created scopes based on buildings. When a new switch is brought online, I'd like to drop that switch into the scope for the building it's in and push the policy ...
I'm having the same issue, it's a 3850-48P-S. I've followed the document below for the emergency-install procedure and It still comes back :
Verification Error: bootloader failed self-verification!
switch:
http://www.cisco.com/c/en/us/td/docs/switche...