Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a Cisco SG 300-52 52-Port Gigabit Managed Switch. On the switch i have two ports which are connected to the guest vlan.Now i want to activate the port security on the two ports. Is it possible to allow two mac addresses on one port? This is...
Hi, I have configured a Microsoft Server 2008 R2 with Radius Server and connect it with a Cisco SG300 Switch.If a new device connect to the switch it goes automatically to the guestnet. If a device with the correct certificate and a valid useraccount...
Thanks a lot Graham. That is working for me.Now I have the problem that the "message button" which connect the users directly to the mailbox not working.Did anybody have an idee where I can enable or disable the "message button"?
I have the same problem.I can enter the command:UC01#conf tUC01(config)#telephony-serviceUC01(config-telephony)#no voicemail conversation caller recording-promptBut nothing happens. The prompt is still played.
I configured the Interface like this:Then I connect Notebook 1 to the Port and it is connected to the network. If I connect notebook 2 to this Port it can also connect to the network. I set the Max No. of Address Allowed to 1 because I have only 2 No...
