dominique.guyer

dominique.guyer · 06-18-2013

Thanks a lot Graham. That is working for me.Now I have the problem that the "message button" which c...

dominique.guyer · 06-12-2013

Hello AlexanderCan you please explain where exactly in CUE I must configure the Option (printscreen)...

dominique.guyer · 06-11-2013

I have the same problem.I can enter the command:UC01#conf tUC01(config)#telephony-serviceUC01(config...

dominique.guyer · 03-21-2013

Thanks a lot Tom. After I had looked the port and add the 2 mac addresses to the static address list...

dominique.guyer · 03-20-2013

I configured the Interface like this:Then I connect Notebook 1 to the Port and it is connected to th...

dominique.guyer · 03-19-2013

Hi,I have a Cisco SG 300-52 52-Port Gigabit Managed Switch. On the switch i have two ports which are...

dominique.guyer · 10-12-2012

Hi, I have configured a Microsoft Server 2008 R2 with Radius Server and connect it with a Cisco SG30...

dominique.guyer · 09-13-2012

Hi SCC Team,I have again a problem with the call logs:I try to changed the sort order by clicking on...

dominique.guyer · 09-03-2012

What about the extension mobility? Does the new version support the extension mobility?

dominique.guyer · 08-27-2012

Another big point would be the terminal server support. Would this be possible with the new version?

dominique.guyer · 08-24-2012

Hi, we have tested the beta version this week. The beta version is much better than the version 2.01...

Re: CUE: disable prompt "Record your message after the tone."