About MOHIT SINGH

MOHIT SINGH · 03-03-2019

You can just create another POTS dial peer with destination pattern .T and PRI port to send out calls through PRI.

MOHIT SINGH · 03-03-2019

Hi Yenosh,It depends how your setup is but normally an inbound call flow will be as belowMobile --> PSTN network --> ISDN PRI line --> Voice Gateway --> MGCP/SIP/H323 --> CUCM --> IP PhoneNormally ISDN PRI have a range of DID numbers that will be ass...

Re: Inbound sip-profiles not working · 12-11-2017

I don't think it will work in inbound dial peer. You should assign the profile to CME2 outgoing dial-peer for it to work.

MOHIT SINGH · 12-11-2017

I will suggest you to check if there is any issue with network that can stop TCP message from phone to primary CUCM server or vice versa. You can do following: 1. Try to ping this IP phone from CUCM server and check if it is reachable. if not then th...

MOHIT SINGH · 12-10-2017

Hi,It is the phone that decides when to un-register from SRST router and register back with CUCM. As soon as the connectivity comes UP with CUCM phone will register back to CUCM. In the 7965 phone settings-> can you check if the primary CUCM IP is c...

Member Since	‎02-08-2013 01:33 AM
Date Last Visited	‎12-20-2020 10:33 AM
Posts	130
Total Helpful Votes Received	106

User Statistics

User Activity

Re: H.323 Gateway config for FXS

Re: Incoming Call flow in cucm

Re: Inbound sip-profiles not working

Re: Phone registered in SRST

Re: Phone registered in SRST