Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have configured host onboarding with closed authentication but process shows me an error. This is the error: NCSP10000: internal error Can you help me?
Hi, I would like to know if it is possible to modify the vlan ID assigned dynamically when host onboarding provisioning is configured. if it is possible, i would like to know how i can do it. Br, Fidel Gonzalez
Hi,
I have configured a vpn site to site between two ASA, the VPN is up but i dont have ping between the inside network (Protected networks)
I reloaded the Ikev1 and ipsec service and the problem continue, i modify the ipsec paramenters wit...
Hi,
I having problem to configure a VPN Site to Site between to routers cisco, 877 and 2911. looks like the phase 1 is ok, but the phase two has problem.
I have nat transpareny configured on both router but is not working. i think that the proble...
Hi,
I need some help for migrating VMs from Blade M2 cluster to M4 Cluster, when i tried the migration it shows me an error and i can not do it the migration but if I enable EVC with Sandy Brigde, the Migration Works, but i do not want to enable EV...
Hi Mike,Can i modify the vlan ID when the host onboarding was already configured?I have already configured the host onboarding, the problem is that I am using Virtual machines, I have a port channel (Trunk Mode) on the edge switch, and several server...
Thanks for the help, your information was important to fix the problem, i had a nat problem in my configuration, thank you very much.
Br,
Fidel Gonzalez
Hi,
Have specified in the access list the remote local network, now i have ping but the traffic is not encrypted, the interface tunnel is allowed me access not the vpn.
protected vrf: (none) local ident (addr/mask/prot/port): (192.168.1.0/255.255....
