I'm trying to generate a report for a asa so you understand if someone has changed the configuration, switches operate normally for asa not. the Cisco ASA is supported?
... View more
I think I've identified the problem switches to which they are connected hosts are on a switch found Inventory> Device Administration> Add / Import / Manage Devices. But it is his default gw, is interface vlan of a nexus 7000, I read that lms for discoverer the host must have its default gw in Inventory> Device Administration> Add / Import / Manage Devices .LMS supports only Cisco default gateways . Solutions? Thanks Emiliano
... View more
Thanks , I checked the xml and everything is correct, I tried to do the reset of the db. As you can see in the screenshot the ratio is 1-894, today went to 14-1045? As if it was too slow? Emiliano
... View more
I did what you told me this is the screenshot but now the ratio is 1-894 why? if I do a search of a PC in the network can not find it .... The setting these so I left the default
... View more
Hi , I reinstalled lms because I had problems on the server, they are now more than a month that the new use but I have trouble seeing the hosts connected to a switch or rather I see only a few. The settings are identical to the old man all by default, but with the old man had acquired many hosts. I suggested a way to make a little troubleshooting. I attach screensshot. Thanks Emiliano the old had over 5000 acquisitions
... View more
Hi Svetlana i have the same problem with cisco plrime lms 4.2.4 ca you help me , i I did what you described putting the path : E:\\CSCOpx\\campus\\lib\\classpath (with two backslashes) E:\CSCOpx\campus\lib\classpath (without two backslashes) But ANIServer Failed to run Thanks a lot E.
... View more
I have read all the documentation found, but to this day I do not understand how that part of wips (ips) is configured as it behaves just like ids. Have you any idea how to configure it to use it as prevention as happen ips for forms of 'ASA. Thanks a lot E.
... View more
Thank you for your response carefully read the faq, because your preparation you can give me an answer to this question that I opened Thank you very much. https://supportforums.cisco.com/message/4047142#4047142
... View more
I can not understand In the product documentation is told: The Cisco Adaptive Wireless IPS system not only is an IDS (Intrusion Detection System), but also is an IPS (Intrusion Prevention System). But with what types of attack works as IPS and where you configure the policy in case of prevention? THANKS Emiliano
... View more