About Jinesh Patel

Jinesh Patel · 07-28-2015

HI, My company uses a DDI range for example, 0208 5556789 - we use a translation pattern to change this (or rather, 556789) into internal numbers/extensions, example, 1XXX. My question is this - as we start to bring in remote sites onto the centraliz...

Jinesh Patel · 06-19-2015

Hi All, In need of some assistance with Hunt Group Voicemails using Platforms - CUCM v10.0 and Unity v10.0 I've created a hunt group for 3 phones/lines. This element works fine, however, if no one answers, I would like it to go to global VM that any...

Jinesh Patel · 12-22-2014

Hey, I have just introduced a Cisco ASA into my environment but having major issues working out how to fit it in. I have tried to configure it as per the proposed solution but not really working Currently2960 trunk port to >1921 (10.10.1-11.1) (for ...

Jinesh Patel · 06-19-2013

Hey Guys, I have a central site which I can remote into using Remote VPN (ipsec). From the central site, i also have a permanent VPN to a branch location which i use for backups etc. Both Central and Remote routers are 887secPoint is, rather than c...

Jinesh Patel · 03-14-2013

Hi All, Trying to get my 887va setup for VDSL but can't get to anything on the net - Controller VDSL 0vpdn enablevpdn-group 1interface ethernet0no ip addressip tcp adjust-mss 1452shutdowninterface ethernet0.101encapsulation dot1q 101ip virtual-reasse...

Jinesh Patel · 06-23-2015

Thanks Charles.It continued not to work so i used the Remote Port Status Monitor and realised that it was masking the calling number, as per the default voicemail profile, when 'entering' Unity. We ended up changing this and hey presto, it now works...

Jinesh Patel · 12-22-2014

Jon, once again, much appreciated.To answer your questions - a) - it's not...your 'note' was actually correct. I had an inkling this might be the case but wasnt actually sure why...you have helped confirm thatb) - 10.10.1 - 10.10.11 are the vlans th...

Jinesh Patel · 12-22-2014

Hi Jon, Thanks for your prompt response, it is very much appreciatedit's not a typo i'm afraid although i think i see your point. My thinking here is/was that i wanted separation between the 'internal' and 'external' elements of my network and creat...

Jinesh Patel · 03-18-2013

Paul, I'm going through the differences now betwen your config and mine to decipher what the difference is. But in the meant time, whatever the difference, it's WORKINGI'm adding a sh run of my config which takes account of the changes you asked me ...

Jinesh Patel · 03-18-2013

Hi, Thanks for your responseI did have the ip route 0.0.0.0/0 d1 command applied but did not show it, apologies.Here are the current errors that i see - 1 - Initial Error - Mar 17 17:33:19.395: Sending PADI: Interface = Ethernet0.101Mar 17 17:33:19....

Member Since	‎01-17-2012 12:59 PM
Date Last Visited	‎09-06-2017 09:07 AM
Posts	14

User Statistics

User Activity

Call Manager Dis-Contiguous Number Range

Hunt Group Voicemail

Introduction of Cisco ASA into Environment

Routing over Remote VPN through to PTP VPN

Cannot access internet using 887va sec and plusnet (BT) VDSL service

Thanks Charles.It continued

Jon, once again, much

Hi Jon, Thanks for your

Re: Cannot access internet using 887va sec and plusnet (BT) VDSL

Cannot access internet using 887va sec and plusnet (BT) VDSL ser