skelley5000
Level 1
Level 1
Member since ‎07-23-2012
‎08-10-2018

User Statistics

  • 60 Posts
  • 1 Solutions
  • 4 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
1 Accepted Solution
1 Helpful Vote
10 Replies
20 Replies
5 Replies

User Activity

I am seeing this on one my uplinks on a 3850 I currently have up and running. This is a layer 2 connection that is trunked with a 3750, both ports on each switch are configured for the correct VLAN's but one thing I did notice is the uplink on the 37...
I have 4 radius servers setup on my switchMy question is I believe if there is no response from the first radius server it will try the second and so on, but what if the authentication is rejected will the switch still try the next radius server?
I am adding my Cisco 3750's into prime and I would like to enable NMSP fro each switch using prime.So far I have only found the way to do this is by editing each switch once Prime has synchronizing with the switch. Is there away to do this in bulk? I...
I upgraded my controller and pre-downloaded the image to all of the AP's for a later reboot. When I try to reboot the controller I get the following message.AP software being upgraded, please try again later  All AP's show the image has been pre-down...
I started planning to upgrade the code on my controllers with a certain code that I felt would be right for my company, but after talking to my Cisco rep we decide to move a newer version.My question isI loaded the code I thought I was going to onto ...
Community Statistics
Member Since ‎07-23-2012 02:04 PM
Date Last Visited ‎08-10-2018 12:04 AM
Posts 60
Helpful Votes Given To