Hello,
According to Cisco Feature NAvigator tool, seems the MTP feature (included in the Feature category named "DSP Media Services: Transcoding, Conferencing, MTP, TRP") is available only for XE versions running on hardware platforms ISR 4400, 4...
Hello, I am having problems to register my iphone client to CUCM. I am using CUCM 9.1.1 with last COP file installed and Jabber for iphone 9.1. I have followed all the steps according to the Admin guide1.- Change Service Parameters > SIP Dual Mod...
I have a customer with a topology as following:(HQ) CCM --- WAN --- (BRANCH) VoiceGW --- H.323_GatewayNormally the branch's outgoing calls goes through the H.323 Gateway which is registered with the CallManager as a regular H.323 Gateway and it works...
We are using a CallManager 5.1 and we are experiencing authentication issues on the CallManager Administration page.This error occur ocasionally and the only way that we have found to solve this is rebooting the whole system.Any idea??The exact versi...
Hi, Does anybody know if it's possible to add a static unicast mac-entry with several output ports?I know that this feature is avaliable on Cat 2900, 3500XL, but does anybody know if this feature is avaliable in another newer model??
Thanks for link Manish,
Seems definitively the DSP related features are not supported including the Hardware based DSP, i still have the doubt with the IOS Software based DSP that is the feature i was looking for.
Could anyone confirm the IOS softwa...
Hi Rich, According to Microsoft, you need a "bridge" (MCU) to allow third party Video Terminals (i.e. CUCiLync) to interoperate together. Take into account that Lync/OCS client uses RTV as codec and a transcoding device is needed to adapt the MS p...
The "switchport host" macro available in most of the Catalyst IOS based CLI is a very useful tool to optimize the port for a host connection, the switchport host command sets switch port mode to access, enables spanning tree Port Fast, and disables c...
Hi Golch, you can control whether a phone has access to the Settings menu by using the Settings Access field in the Cisco CallManager Administration Phone Configuration page. The Settings Access field accepts these values: â¢Enabled-Allows access t...
Hi again, Brandon,Maybe you misunderstood the question. The topology is as following:(CISCO IOS SRST) --- non-cisco h.323_GW - PSTNYou I was referring to the configuration at the SRST router.Hope this clarify the question.