Hello, I tried to migrate a VPN we have that originally went from a remote site (not managed by us) to our WAN provider (not managed by us) and instead from this remote site to us direct as we are removing our WAN provider. So I built the VPN using a...
Hello, I noticed on our 5508 WLC that an access point on the roof of one of our buildings is down (roof terrance). On the PoE switch is now shows Ieee PD instead of AIR-CAP1532E-EK9I have done a shut and no shut and I get the same. Nothing shows wit...
Hello, Our Cisco Prime doesn't want to load it's webpage today, has anyone experienced this before? I will be de-commissioning it at some point as we have another Prime server, but I need to get the floor plans off it. I can SSH to it though, so I'm...
Hello, None of us can work this out. I wonder if it's the 4 hour ARP ageing? So we have a remote site with a single Cisco 3850 with a few devices plugged in and 2 x Cisco IE2000 switches trunked to the 3850. All 3 switches have default gateway that ...
Hello,I need to remove an old syslog server and add a new one to 2 our our Cisco Nexus 3k switches, but it won't do it. sh run | inc logging
logging logfile messages 7 size 100000
logging distribute
logging server 192.168.18.9 6 use-vrf Unknown
logg...
Thanks I did just notice when using the Tunnel mode I had this and wondered if that is why phase 2 failed.I saw a: % Network not in table I had:ip route 192.168.1.0 255.255.255.0 Tunnel20ip route 192.168.2.0 255.255.255.0 Tunnel20ip route 192.168.3.0...
sh interface Gi2/0/1 controllGigabitEthernet2/0/1 is down, line protocol is down (notconnect)Hardware is Gigabit Ethernet, address is 00f2.8b18.2901 (bia 00f2.8b18.2901)Description: AP PortMTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,reliability ...
