Hi everyone!we are have a problem with enabling vc on EoMPLS circuit on Cisco ME3600x. all configuration is the same and working, we are checked ping, traceroute, ping mpls ipv4, ping mpls pseudowire, every our trying was clear and well, but when we ...
hallo every one!i need setup vpls between two CPT 600 and can ping between 2 me3600 switchesbetween cpt 600 i was setup ospf and mpls and setup vpls, but my me3600 switch can not pingwhat i do wrong?my topology in attachmentthis is my hardware config...
when i configure pw-class i cant add "ip local interface loo 0" on both side, because in my equipments does not present this commandin this time i have this configuration on the both side:KAND_sw1#sh run | b psepseudowire-class eompls encapsulation m...
in our cisco ME3600x local interface is interface VLAN 1517.KAND_sw1#sh inter vl 1517Vlan1517 is up, line protocol is up Hardware is EtherSVI, address is 78da.6ead.7a40 (bia 78da.6ead.7a40) MTU 9212 bytes, BW 1000000 Kbit/sec, DLY 10 usec, re...
hi!i have same a problem. but if use I/O Mode 2 or Mode 3 i cant enable mpls functions on tengig ports. can you tell me, what i need to do for usage 4 tengig ports and usage in this port mpls functions
