Hello, My AP02 is configured as repeater, and my device/iphone is associated on that AP02#show dot11 associationsMAC Address IP address IPV6 address Device Name Parent State3c2e.ffb5.d20c 192.168.1.20 2A01:E34:EC08:8F70:FF0B:A1FF:FE16:13EE unknown - ...
Hello,I'm trying to use OTV to extend my vlan 101C3850West Gi1/1/2 <-> Gi0/0/1 ASRWest Gi0/0/0.900 <-> ISP <-> Gi0/0/0.900 ASREast Gi0/0/1 <-> Gi2/0/24 C3850East On both C3850 I created an interface vlan101West----interface Vlan101ip address 10.216.1...
Version: 3.06.06E
Platform: WS-C3850-48U
Hello,
I'm seeing output drops on an interface connected to a Wifi AP
The switch uplink is 10G and the AP is connected to 2x1gi => Po
N9K <-- Po=2x10G --> C3850 <-- Po=2x1G --> AP2802i
My understanding i...
Version: ISE 1.2p12Hello, I have trouble authenticating devices that use different protocols:- Cisco IP Phones: EAP-MD5- Windows machines: EAP-PEAP- Cisco APs: EAP-FAST 1) I'm able to authenticate the IP Phones individually with a authentication rule...
Cisco ISE: 1.2Switch IOS: 15.0.2.EX4 Hello,I have configured the APs to authenticate with 802.1X via the switch.When I shut the port on which the AP is connected and then no shut it, the port comes up a few seconds later and the switch sends a dot1x ...
Hello,Thank you very much for your quick answer.I reenabled "no otv suppress arp-nd" after my tests.The action that solved the problem was "no mac access-group otv_filter_fhrp in"So as you said the problem was the access-group which I didn't suspectm...
