About Moh Mogh

Moh Mogh · 07-13-2015

Hello everyone,I would like to configure route damping on two routers, each receiving Internet routing table from two separate eBGP neighbors.We are a Cloud service provider, so obviously route stability matters and that's why we were thinking of imp...

Moh Mogh · 12-17-2015

Hi, As far as I know, reloading the vdc is optional, you can check if everything is going well after the rebind interfaces with show vdc detail. In case you are creating a new VDC, then you can only reload the new vdc with reload vdc NEW. I assume th...

Moh Mogh · 12-17-2015

Hi, Nexus series support Online Insertion and Removal, so a reboot is not required. Regards,Mohammad Moghaddas

Moh Mogh · 12-17-2015

Hi, an output of show run, excluding any possible sensitive information, would be helpful. As a checklist, make sure you have defined correct IP addressing, NAT, access-list and security-level, plus interface zone definitions. One question, do you wa...

Moh Mogh · 12-17-2015

Hi, I'm more suspicious of a Layer 1 issue. Check the transceivers and the links between chassis. To rule out some possibilities, you can try swapping the transceivers, swapping the ports, etc. Also a show run of the VSS configuration would be helpfu...

Moh Mogh · 12-17-2015

Hi, If you really wanna make it so complex, then create a SVI for VLAN10 on SW2 and assign an IP address in the same subnet. Use that IP as the default gateway for the server. Then, you also have to add a default route on SW2 having firewall as nexth...

Member Since	‎02-18-2014 11:17 AM
Date Last Visited	‎09-22-2023 11:07 AM
Posts	35

User Statistics

User Activity

Route damping on two routers, each receiving Internet table from 2 eBGP uplinks

Hi,

Hi,

Hi,

Hi,

Hi,