Hi, I have set up a VPN site to site using Cisco ASA 55xx Tunnel only comes up when traffic is iniciated only from the remote peer side. My packet tracer shows that VPN encryption is being dropped. When tunnel has been started by peer and is up, I th...
Hi guys,
I have a BGP point to point connection over a 100Mbps link between Branch office and Main office, connection via ISP.
I have set up under two cisco routers 2801 with advance security ios a GRE tunnel running ospf protocol so I can share mu...
Hi guys,
I have a BGP point to point connection over a 100Mbps link between Branch office and Main office, connection via ISP.
I have set up under two cisco routers 2801 with advance security ios a GRE tunnel running ospf protocol so I can share...
hi guys,
I have set up an hsrp between 2 Catalyst 4000 L3 Switch Software (cat4000-I9S-M and has been giving me problems for the past 2 weeks. I have the topology attached.
The hsrp Lab is working fine when one switch port track interface goes down ...
Hi guys,
I have a working POE module of 48 ports (WS-X4248-RJ45V) on my C4503-E switch and I would like to use the module on my other switch C4507R.
The switch recognizes the POE module but it does not power my poe devices such as IPhone even after I...
can you share discussion link about software limitation or equipment. I would like to know of options Cisco equipment to purchase or software that will help me get the most out of 100 Mbps WAN link on a tunnel GRE?
Hi terence,
what about bandwidth limitation, so how much bandwidth max could I get on my GRE Tunnel using a 2801 router?
I will enable PMTUD as I was just reading it about it earlier, do I add on both routers and would you please share the syntex?
It was defenetly something wrong with the firewall and my core switches, firewall statefull inspection so I had to change my topology in order for the firewall to have only 1 inside interface and still connect both Core switches. All is working fine ...
