About Mike Schultz

Mike Schultz · 04-14-2015

Greetings,I've been scouring Cisco.com and Google looking for documents relating to configuring the Interframe Gap/Interpacket Gap (IPG) and I can only find one document that describes how to change it, except for it's specific to a 6000 series switc...

Mike Schultz · 12-02-2014

I've been poking around in a few test routers trying to find where BGP states how long a route has been known from a neighbor. Based on Cisco's BGP path selection article: http://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/13753...

Mike Schultz · 10-06-2014

If I run the following command on a 6500 series switch:sh platform hardware capacity fabricI get the following output:Switch Fabric Resources Bus utilization: current: 0%, peak was 24% at 07:25:01 PDT Tue Aug 6 2013 Fabric utilization: Ingress ...

Mike Schultz · 04-10-2014

Is an 8-fiber MPO connector compatible with a 12-fiber MPO connector? I cannot find this information anywhere.

Mike Schultz · 04-08-2014

I'm trying to select the correct cable to connect to a Cisco Nexus 40G-FET (on a Nexus 6004). I've seen on Cisco's website that says the FET transceiver has 12 fibers in it. Yet when breaking this out to connect to four 10G FETs on a FEX (2232TM-E), ...

Mike Schultz · 04-21-2015

Is the 2921 going to be also providing the WAN connection to the larger office? If so, what is the throughput requirements?

Mike Schultz · 04-21-2015

I thought I'd put a follow-up to my original question in case someone in the future is looking for more information on this. I was originally looking for information on this topic because my organization has been having throughput issues with one of ...

Mike Schultz · 04-15-2015

Can you provide the config of G0/1 on the switch?

Mike Schultz · 04-14-2015

I'm not sure I completely understand your intent, but I'm also not sure you completely understand the function of the native VLAN. You perhaps do. But just in case: The native VLAN function on a dot1q trunk means that any frame coming from the native...

Mike Schultz · 12-03-2014

That's getting sidetracked. My issue isn't path selection manipulation. I can configure BGP to choose whatever path I want it to choose.Cisco routers choose BGP routes based on a certain set of criteria that we call attributes. I can see all of the a...

Member Since	‎02-27-2014 08:31 AM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	24
Total Helpful Votes Received	21

User Statistics

User Activity

Interframe Gap - Is it configurable?

BGP Path Selection - Favor Oldest Routes

How to see 4500 switching capacity

8-fiber MPO and 12-fiber MPO Compatible?

Cisco Nexus 40g-FET

Is the 2921 going to be also

I thought I'd put a follow-up

Can you provide the config of

I'm not sure I completely

That's getting sidetracked.