About libbistovall1

libbistovall1 · 03-13-2014

I have attached the configuration for both my Raleigh and Dallas routers. Using putty, I can telnet to the Dallas Router via a direct ethernet connection. I have the Raleigh Router configured the same way, but I get "connection closed by remote host"...

libbistovall1 · 03-13-2014

Please take a look at the attached diagram; I made the diagram in packet tracer, but it is just a diagram of my home network. I have also attached the config and route info for both routers.The PC in Raleigh can ping the Seattle router, but the Seatl...

libbistovall1 · 03-12-2014

I bought Cisco WIC-2A/S Wan Interface Cards http://www.ebay.com/itm/161087476330?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649 and I can't get the line nor the protocol up on these cards. Isn't the light supposed to come on when I connect the se...

libbistovall1 · 03-18-2014

I mistakenly noted this as the correct answer. The answer was that ethernet port was bad on the Raleigh router and the slot with that I had the serial card in on the Dallas router was bad. What do you want for a $20 router.

libbistovall1 · 03-13-2014

Thanks again Jon for your help. It helps to have someone go through problems with when you are learning. Just articulating the problem helps. If you get a chance, please do look at my telnet posting - I can telnet to Dallas, but not Seattle or Raleig...

libbistovall1 · 03-13-2014

I deleted the config before setting it up. Your instructions say that after you 1st four steps that I should ping from Seattle to see if the lists had any hits; so you didn't expect the ping to successfully get to the PC, just that they would registe...

libbistovall1 · 03-13-2014

Jon,Your access list solution worked. I don't know why Dallas and Seattle could no longer see the 4.0 network and why the PC was no longer pinging its gateway. Your right, I had to resolve that first. I moved the PC over to Raleigh's fa0/1 and it was...

libbistovall1 · 03-13-2014

Problem still not resolved: Neither Dallas nor Seattle can see the 4.0 network. I did resolve the screwy wan card issue; it was the slot. I removed a card I wasn't using and moved the wan card over there. Now the ports are what they say. That did not...

Member Since	‎03-02-2014 08:13 AM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	20

User Statistics

User Activity

Telenet from direct connect PC over ethernet - connection closed by remote host

Routing issue on home network

Can't get line or protocol up on serial interfaces

I mistakenly noted this as

Thanks again Jon for your

I deleted the config before

Jon,Your access list solution

Problem still not resolved: