Hi Tenaro,The link you mentioned is a good one.Wikipedia has a great and simplest definition around :Fabric Shortest Path First (FSPF) is a routing protocol used in Fibre Channel networks.It calculates the best path between switches, establishes rout...
Hi Evan,You can use my favorite command as below to find out the cost and check what path traffic will take. Here is a example :switch1# show fspf internal route vsan 2
FSPF Unicast Routes
---------------------------
VSAN Number Des...
Hi Evan,Please note that in MDS for FSPF uses load-balancing algorithms based on source FC ID, destination FC ID, and exchange ID which are enforced in hardware. Further please note that :> FSPF supports load balancing of traffic between equal cost p...
Hello,I do not think you can have cascaded NPV switches connected to a NPIV switch. Again I would have to deferFrom the below doc it says :"Connectivity from an FCoE NPV bridge to the FCF is supported only over point-to-point links."http://www.cisco....
interface Vlan10 no shutdown management <<<<<<<<<< ip address 10.1.1.1/24Try the above in 5.1.3(N1)1 code ir after and then see if you can telnet or ping the SVI