Help Me
I have a LAB with 4 IPNs. With 2 IPNs per pod. And 2 Spines per pod however the spines are only connected to 1 IPN (see image)
Should there only be 1 IPN TEP address in each pod that's shared by spine 1 and 2 ?
Or should there be a IPN TEP ad...
Please can someone help with this LAB, I have the following topology shown in the Left hand side I am trying to set up the Tenant as shown in the top right, Once setup as shown EPG-b to EPG-c can communicate but not EPG-a to EPG-b. I believe this to...
I have a 3850 and want it to download its config from APIC-EM with NO intervention of the switch i.e power the switch on and it automagicly connects to the APIC-EM and installs its confg.So...I have a 3850 with new software ---- cat3k_caa-universalk...
Thanks guys for the info,
@nvermand I the TEP I am referring to is the one used for BGP. I am presuming CP-ETP stands for Control Plane Evpn Tunnel end point.
I can now ping the CP-ETEP at both ends. FYI I fixed this by simply removing and re-add...
HALT !!!!!!!
Because its a Wednesday evening I went and did something crazy and configured HSRP on all 3 interfaces on the 4500. Then did the ping tests to the HSRP VIP's and not the interface IP's addresses and it works.
<If me, Robert and Chris ak...
Ok so just managed to get the new ports connected up. The results however are still the same, in that EPG-alpha can ping EPG-beta (they sit in different BD's). However EPG-alpha cant not get to EPG-gamma ( both sit in the same BD).
So now each EPG no...
Well cover me in sugar and call me a doughnut !!
That looks like it could be it.
Was just looking at the same Cisco page you sent in your link. And yes is not possable.
However for completeness what I will do is connect up 2 more physical ports, so 3...
