Hi, I have setup a HQ and Branch office. HQ is setup as Customer service location and Branch as Sales location. When PSTN calls Customer Service 800 number, the application runs fine. But when PSTN calls Sales 888 number, the call gets disconnec...
Hi,I am working on a class project for voip. I have got everything setup and working. HQ is configured with MGCP gateway and Branch is configured with SIP trunk.One of the requirement is that to "place two active calls between HQ and Branch and have ...
Hello everyone, I'm working on a class project on voip and have a little knowledge on it. I'm using CUCM 8.6. I setup HQ with MGCP gateway. The gateway is connected and working. I need to setup SIP voice gateway for Branch. How do I configure ...
Hi everyone, I am working on a voip class project. There's a HQ and a Branch. The CUCM cluster is in HQ and consists of a publisher and a subscriber. I configured the multicast MoH for HQ and Branch phones. But the MoH is not working in Branch pho...
We have a router setup as a PSTN router and an IP phone configured as a PSTN phone and 800 and 888 calls come from that phone.Our HQ is using a MGCP gateway and Branch is using SIP trunk. I configured dial peer with the destination pattern pointing t...
Thank you Carlo for the reply. I have G711 as the codec used between CUCM and UCCX. I also configured a transcoder in HQ gateway router and CUCM but that didn't help.
I configured one MRGL and assigned it to Branch and HQ phones. User hold source are also configured. I am using HQ router to stream the MOH.I set The max hop count to 3.I have HQ router, Branch router and WAN/PSTN router