Hello,I have a weird problem with clients connectivity through IPSec. I have setup an ASA5520(8.3(2)) as a VPN concentrator. The DHCP is served from windows machine.From time to time it happens, that no one can connect - immediately they get 433 Erro...
Hi all,I have a problem, that interfaces shows as up, but it does not actually work - it doesn't work.When I tried vemcmd show port:LTL VSM Port Admin Link State PC-LTL SGID Vem Port 18 Eth4/2 UP UP F/B* 0 vmnic1 4...
Hi,I'm rather new to the ASA box. recently I tried to use:asa#show ip route <dest_ip>which is not an asa command, ok. But show route does not accept parameter as an destination ip address. I have many outgoing interfaces (20 or so) which are only int...
Hi all,I ordered rackmount server(C210 M1) with Broadcom NetXtreme II 57711 which I would like to connect to Cisco UCS 6120 in switching mode, but I can't make it working. Broadcom has 2 slots for SFP/SFP+ so I inserted Cisco SFP 10GBase-SR into it. ...
Hi, is it possible to change the thresholds levels which are showed by show interface tranceiver detail? I have badly calibrated SFPs which generate a lot of logs. I'm using c4506E. Thanks for any hints.
interesting thing is, that now the command show port vlans display the native vlan correctly as 104: Native VLAN Allowed LTL VSM Port Mode VLAN State Vlans 18 Eth4/2 T 104 FWD 5,10,104 49 Ve...
I just added vlan 104 to the system vlans section on the Rack4Uplink and now it works. But I don't know why it should not work...? (show module showed all modules and both VSMs)
Hi Michael,my setup is that I have two servers connected via switch (which does not understand vlans), essentialy I have only one data vlan 104. The whole setup was working, but then I tried upgrade to 4.2.1(4a) and now I lost connectivity to that vl...
unfortunately, this is not at all useful.a) you must specify outgoing interface - that is exatly what I would like to avoid (I have too many of them)b) as you can see even if you specified the IP address it actually printed out all configured routes ...
Hi,this will actually help. It is not exactly what I was looking for - it needs some refinement in case of suppernetting, but it is viable.Is there an alternative to #show ip route ?