About pablitomassa82

pablitomassa82 · 10-15-2018

HI Everyone, i would like to do some factory acceptance test on the cisco 4430 and 4330 routers. Where can i find the reference document with the procedure? Which commands are generally used to carry out this tests? Thanks a lot Paolo

pablitomassa82 · 06-11-2018

Hi everybody, I know that default behaviour of Cisco is to create FECs based on the destination prefix known to a router (IGP prefix in the routing table). Is there a specific command to show a list of FEC created on a router? i know only show mpls f...

pablitomassa82 · 05-21-2018

Hi everybody, i have the following problem (see the picture below): The NMS Server need to know the Loop 1, 2, 3, 4 and 5 addresses in order to manage the routers associated with these addresses. The routers associated with these addresses runs their...

pablitomassa82 · 04-13-2018

Hi! I have the following scenario: 3 blue routers are connected in Area 100 OSPF and the two edge router (the blue router on the left and the blue router on the right) have also one interface in Area 0 OSPF and are connected by a link in a VPLS. La...

pablitomassa82 · 04-12-2018

Hi everybody, i have two identical point to point connection each with 150Mbps of bandwidth. I run JPERF on the two links with the following settings: -TCP dual - 10 parallel stream (to saturate the bandwidth) On the first link, every parallel stre...

pablitomassa82 · 05-22-2018

Thanks Richard, i've simulated the two solution with GNS3 and it works! Paolo

pablitomassa82 · 05-21-2018

Hi Richard, thanks for your answer, you perfectly understood what the problem is. The second solution you offered me is very interesting: you suggest me to create a second OSPF process (router ospf 2 - green OSPF) on R1 and R4 and establish an gree...

pablitomassa82 · 04-14-2018

Hi! Thanks for your answer, i was also thinking about traffic black holing due to time of reconvergence of OSPF or OSPF-LDP time of synchronization.....i waited few second (2 or 3). Tomorrow I will repeat the test waiting more and i let you know. Th...

pablitomassa82 · 04-12-2018

i answer myself,....i rebooted the PC and now it works

pablitomassa82 · 02-28-2018

To resume: Is this scenario, when SDH link fails is better: 1) That interface fa0/1 of Router 2 and Fa0/0 of Router 3 remains UP 2) That interface fa0/1 of Router 2 and Fa0/0 of Router 3 goes DOWN I think it's better the Option 2 because prevents s...

Member Since	‎04-11-2014 06:29 AM
Date Last Visited	‎09-01-2020 11:06 AM
Posts	37

User Statistics

User Activity

Cisco 4430 and 4330 Factory Acceptance Test (FAT) command

MPLS Forwarding Equivalence Class

OSPF topology and redistribution problem

Traceroute behaviour in this scenario

Jperf problem

Re: OSPF topology and redistribution problem

Re: OSPF topology and redistribution problem

Re: Traceroute behaviour in this scenario

Re: Jperf problem

Re: OSPF + SDH + BFD Question/Problem