pablitomassa82

pablitomassa82 · 10-15-2018

HI Everyone, i would like to do some factory acceptance test on the cisco 4430 and 4330 routers. Whe...

pablitomassa82 · 06-11-2018

Hi everybody, I know that default behaviour of Cisco is to create FECs based on the destination pref...

pablitomassa82 · 05-22-2018

Thanks Richard, i've simulated the two solution with GNS3 and it works! Paolo

pablitomassa82 · 05-21-2018

Hi Richard, thanks for your answer, you perfectly understood what the problem is. The second solutio...

pablitomassa82 · 05-21-2018

Hi everybody, i have the following problem (see the picture below): The NMS Server need to know the ...

pablitomassa82 · 04-14-2018

Hi! Thanks for your answer, i was also thinking about traffic black holing due to time of reconverge...

pablitomassa82 · 04-13-2018

Hi! I have the following scenario: 3 blue routers are connected in Area 100 OSPF and the two edge ro...

pablitomassa82 · 04-12-2018

i answer myself,....i rebooted the PC and now it works

pablitomassa82 · 04-12-2018

Hi everybody, i have two identical point to point connection each with 150Mbps of bandwidth. I run J...

pablitomassa82 · 02-28-2018

To resume: Is this scenario, when SDH link fails is better: 1) That interface fa0/1 of Router 2 and ...

pablitomassa82 · 02-28-2018

UPDATED!!!! (in this version i explain more accurate scenario) Hi Everybody, I have this scenario: R...

pablitomassa82 · 01-15-2018

Thanks a lot, i was thinking that you can have only one active (up interface) same ip address on the...

pablitomassa82 · 01-15-2018

Hi everybody, I'd like to configure the same IP address on two different sub-interface on the same r...

pablitomassa82 · 11-27-2017

Hi, thanks for the answer. Did you find any documentation to prove it? i will use BASE IOS XE thanks...

pablitomassa82 · 11-27-2017

Hi Everybody, Is L2/L3 Etherchannel supported on router CISCO 4431? Thanks a lot Paolo

Cisco 4430 and 4330 Factory Acceptance Test (FAT) command