I have a 10M ethernet link and am up/up on the link, I can ping the neighbor, but am not seeing BGP established on my end ("Active").  Telco is telling me they are sending routes, but are not receiving routes from me.  My question is in a state of "A...

We have 100+ IPSEC VPN tunnels configured out to remote locations.  This is a new project - about six months old - and from the start, these tunnels would inexplicably drop.  Many times they would just restore themselves - sometimes in a few minutes,...

I'm creating a script for a new location.  I remember there are only three commands for the router to download it's CCM/mgcp config from the server.  I am sure two of them are as follows, but can't remember the third:ccm-manager config server x.x.x.x...

I'm getting all of the following errors on three different 56K circuits - all are at the same location and all likely riding the same higher level facilities when handing off from teh LEC to our provider.  The building maintenace supervisor has told ...

I am exploring forwarding a number and have been told by our provider that there will still be half a ring that comes through before it forwards.  I attempted to set the ring setting on the line in CCM to "disabled", but it still rings.  I'm not sure...