I am attempting to set up the FastEthernet management port on some 4500x switches that we have recieved for Out-of-Band management, but I am unable to get them working. I have set this up before on ASR1004 routers and have not had any troubles with ...
We finally got the out-of-band management interface working by upgrading the IOS from 3.4.4 SG to 3.4.6 SG on a new 4500X that we just received. Thanks everyone for your help.
No, I have not been able to find a solution for this. As it is I am unable to use the management port on my 4500-X switches for out-of-band management.
I was testing the 172.16.0.0/16 block when I had the management port directly connected to my laptop. When it was connected to the switch it was using a different IP block and the gateway to that block is on a router that is also connected to the ot...
Unless that enabled by default now I have not enabled anything on this switch besides this management port. I even erased the startup-configuration and started over with just this setup. I wanted to get the management port working so that I could set...
Here is the show int fa1 and show run int fa1 while I had the laptop connected and attempted to ping both directions. interface FastEthernet1 vrf forwarding mgmtVrf ip address 172.16.1.10 255.255.0.0 speed auto duplex autoend FastEthernet1 is up, lin...
