About tony_pickett

tony_pickett · 09-21-2015

I have the following configuration (as shown in the diagram below)My Anyconnect user connects to data center 1, but in the event that data center is not available, he should connect to data center 2. The problem I have is two fold:1. My Anyconnect us...

tony_pickett · 04-19-2014

Here is my problem:I have 2 ASAs (5515-x) in a passive fail over configuration.I have a Comcast internet connection with two static IP addresses (one for each ASA) coming in on a single fast Ethernet port.I am told that I need to have a switch to tak...

tony_pickett · 04-25-2014

With one connection from the Comcast box, we can only connect to one ASA, but that does work. We need the switch to break out the second connection to the second ASA.We haven't used that switch elsewhere, but we did use another switch in its place an...

tony_pickett · 04-24-2014

In my initial configuration, I did have the three connections in their own VLAN. When I found that I had no connectivity, I removed all the configuration except the port configs, just to see of that was the issue. Once I get this working, I will plac...

tony_pickett · 04-23-2014

Anyone?

Member Since	‎04-19-2014 05:07 PM
Date Last Visited	‎10-26-2018 12:04 AM
Posts	5

User Statistics

User Activity

Cisco Anyconnect profiles and switching between profiles

Problems with a switch config with ASAs.

With one connection from the

In my initial configuration,

Anyone?