About likewinered

likewinered · 09-26-2019

Hello Experts! I'm currently using three 3595 ISEs. I want to add another 3615 here as a PSN. Currently information ISE1 : PAN(Primary) + MNT(Secondary) + PSN ISE2 : PAN(Secondary) + MNT (Primary) + PSN ISE3 : PSN (Health-Check node) Is there p...

likewinered · 06-22-2016

Dear all, Currently in use AP-1131AG lightweight mode in WISM-1. There are plans to change the WISM-1 with CT8510. But I can not find support the AP1131AG in the CT8510. I want an answer to this problem. Thanks, all.

likewinered · 04-30-2015

Hi All. Last week, I Configured LAG on CT2504 using following configuration: ## CT2504 (8.0.110.0)GUI access, controller -> LAG mode enable and reboot ## C4503 (with SUP7L-E, IOS-XE Version 03.04.02.SG) interface Port-channel1 switchport switchport m...

likewinered · 12-14-2014

Hi, all. I used Static NAT in cisco 2811.But, 2811 Router is not have ARP in ARP table Topology isInternet - Router - Backbone switch - L2 switch - Cisco 2811 Router (this router problem)For example, currently in use the next table192.168.0.100 -> 1....

likewinered · 10-30-2014

Hi all. I want create to virtual phone number on CME.For example, inbound call number is 6000. (This number don't have physical ip phone. Representative number)If, Can I used call-forward to another phone number? And, If it can use, Please give me CM...

likewinered · 09-30-2019

Thank you everyone! I think my explanation is a bit lacking. This is the composition I want to use.ISE1: PAN + MNT + PSNISE2: PAN + MNT + PSNISE3: PSN (Health check node)ISE4 (New 3615): PSN The bottom line is that although this configuration is not ...

likewinered · 09-30-2019

Yes. I using ISE 2.4. Thanks for your reply.

likewinered · 05-06-2015

I can not test with different switch.I was tested disable Port-Channel and Gi2/5 shutdown. But, same issue. DHCP Snooping Config on 4503, Is it not issue?User is used static IP. Thanks your reply.

likewinered · 05-02-2015

Yes, change the physical ports 4503 side & test.But, This issue is same.

likewinered · 10-30-2014

Thanks for your reply. Based on your reply, I create config for sample. Verify please. voice translation-rule 2rule 2 /^6000$/ /60../ Inbound call 01-2345-6000 (Representative number),6000 -> 60xx number. Is this config correct? Thank you.

Member Since	‎04-24-2014 12:08 AM
Date Last Visited	‎12-14-2020 07:42 AM
Posts	20

User Statistics

User Activity

ISE Multiple deployment (3595 and 3615)

AP-1131AG support in AIR-CT8510-x-K9 ?

WLC2504 LAG Issue (a lot of link up/down logs)

1:1 static NAT ARP issue (Cisco 2811 router)

Call Manager Express, Virtual number setting

Re: ISE Multiple deployment (3595 and 3615)

Re: ISE Multiple deployment (3595 and 3615)

I can not test with different

Yes, change the physical

Thanks for your reply. Based