I am trying to change interface IP address using ncclient via netconf and the config which I am trying to do is as below.Please help here to get the IP changed using ncclient for the interfaces in IOS XRv9k """<config> <interface-configurations xm...
Switch forwards certain packets to some other port although corresponding destination MAC address Learnt in a different port in same switch. This has been identified when capturing packets using wireshark in a PC connected to the same switch and in s...
Hi,
I have certain routes learnt in EIGRP and i need to redistribute into BGP.
Please note that I have to filter just specific routes from EIGRP to learn in BGP so I use route-map while re-destributing EIGRP to BGP to filter the prefixes.
I have...
Hi,
I have certain routes learnt in EIGRP and i need to redistribute into BGP.
Please note that I have to filter just specific routes from EIGRP to learn in BGP so I use route-map while re-destributing EIGRP to BGP to filter the prefixes.
I have...
Hi..
I am facing issue in WS-C3850-48P switch for inband connectivity when I enable AAA in the switch with tacacs authentication as its not working at all.
Is theer any bug with this switch or the software we using?
Software Used : cat3k_caa-un...
Please help with the get operations in netconf for XRv9K.I am using ncclient. Please help for sample filters with which I can get interface statistics output. Request someone to please reply / respond to this thread
Hi AllSomehow managed to get config data of interface and to modify.However require your help in sending the correct request format for Get operation in IOS XRv9k please. Like Get interface state etc. Please help here in responding to this thread