Hello, I am trying to use ip community-list together with route-map exact match: ip community-list standard Filter1 permit no-advertiseip community-list standard Filter1 permit 65004:66 However i faced this problem: R(config)#route-map Filter-inR(con...

Hello, Currently have a cisco 7600 router with IOS 12.2(33)SRE12 and would like to rate limit the udp traffic from a host. Currently have this setup:  ip access-list extended LIMIT-UDP-IN remark LIMIT-UDP-IN permit udp host 1.2.3.4 any!ip access-list...

Dear all According to the documentation, it should be supported,  http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/qa_c67-612908.html However, i cannot found out any documentation, or any cases on the internet, that can enable th...

HI all, I Have a 6509 router running in production environment, but I am planning to switch it to a 7604 router. While I dont have the problem of the config between them, it seems that from a unknown reason, there is some MPLS routers that exists on ...

Hi, We are trying to setup port-channel with redundancy 1:1 with our 6509 router,  but we found that we cannot use the command: lacp fast-switchover Router(config-if)#lacp ?  max-bundle  LACP maximum number of ports to bundle in this port channel Rou...