About brettlarkins

brettlarkins · 03-16-2021

Been working more and more with the 9800 WLC's recently and starting to get more comfortable with them... Does anyone know what the equivalent CLI command is in the 9800 WLC for "config ap primary-base WLC03 Cisco_AP_1 192.168.142.12" That was used ...

brettlarkins · 11-18-2019

Standing up a 9800-CL wireless controller. Got through the initial deployment, the Day Zero config, and can log into the WLC, but I cannot get my AP's to join it.AP models are 1832 and 3802. Tried WLC versions 16.11 and 16.12, both with the same resu...

brettlarkins · 07-31-2019

Has anyone had any issues using a console cable on the new 9115AX AP's?Are there any unusual settings, unlike all the other AP's and switches, like a strange Baud rate, or anything?I have a couple console cables that works for all my Cisco gear, but ...

brettlarkins · 12-12-2018

When defining a QoS scheme for your network and carving up bandwidth on your router interfaces, do you need to create a classmap to specifically match IP routing protocol traffic, and then account for that traffic in your policy maps? I recently sa...

brettlarkins · 08-22-2018

Can anyone help me determine what files need to be deleted from flash to completely reset a Catalyst 9300-48U switch to factory defaults? I'm looking to remove everything that has been added since the time it was pulled out of the box... config, vlan...

brettlarkins · 07-22-2022

Currently experiencing the same issue with 9130AXI and 9124AXD AP's using a 9800-CL vWLC running 17.3.4. 5 of my 15 AP's do get DHCP just fine even with repeated reboots. But the other 10 do not get DHCP IP's, even with repeated reboots.

brettlarkins · 03-16-2021

Worked perfectly... Thank you, Rasika!

brettlarkins · 06-24-2020

Yes, trustpoint certificate was my issue as well.Thank you for posting the response!

brettlarkins · 01-23-2020

Turns out it was just a "Bad" AP. I've worked with many 9115 and 9120 AP's over the last 6 months and never encountered this issue again with any of the others. Same console settings as all AP's and switches before... this was just a bad AP.

brettlarkins · 12-12-2018

Hi Dennis, Thanks for the prompt reply... Should I be creating a match statement for CS6, and creating a Bandwidth allocation for that traffic in my policy-maps?

Member Since	‎04-29-2014 09:41 AM
Date Last Visited	‎02-27-2024 02:49 PM
Posts	58
Total Helpful Votes Received	40

User Statistics

User Activity

9800 WLC - CLI command for AP Primary controller assignment?

9800-CL WLC - No valid AP manager found for controller

9115ax cosole issue

QoS needed for IP routing / Network Control traffic?

Catalyst 9300 - complete reset to factory settings

Re: 9130AX Access Point Ignoring DHCP Offer

Re: 9800 WLC - CLI command for AP Primary controller assignment?

Re: 9800-CL WLC - No valid AP manager found for controller

Re: 9115ax cosole issue

Re: QoS needed for IP routing / Network Control traffic?