About teejay1719

teejay1719 · 05-22-2014

hey guys, testing my network using IPSLA but its strange how when i connect a router to the network and input the IPSLA commands it says it fails everytime? Im a student doing my project btw and am unsure why its not sending through the network. I ha...

teejay1719 · 05-14-2014

Hey guys, so i have HSRP configured on two routers and its working just fine, the thing is the two routers are connected to a switch and i have two pcs connected (Pcs running PBX) to the switch. I want to configure NAT portforwarding so that when the...

teejay1719 · 04-29-2014

Hey guys i have been stuck for awhile on trying to redistribute Vlans through OSPF. Ive struggled for awhile now and im still confused. Could i upload my packet tracer file and if possible could you point out where im going wrong? I have added the vl...

teejay1719 · 06-10-2014

Thank you for your reply, i read up and have it all working now! The problem was in the Receiver not being able to connect past its gateway. Thanks again!

teejay1719 · 05-22-2014

I needed it for the PBX to connect to. Its very long to explain but its ok! Thank you for your reply, i tried the Nat with hsrp and it didnt work :S but its fine, im moving on to the next step haha

teejay1719 · 05-01-2014

i have placed the PC ip addresses in the same subnet as the routers gateway havent i? the PCip = 172.16.10.1Subnet = 255.255.255.240Gateway - 172.16.10.10 Router fa0/0 (gateway for PC)ip = 172.16.10.10subnet = 255.255.255.240 Is this correct? and i ...

teejay1719 · 04-30-2014

thank you for replying again! :)So when you say make the router interfaces "known" to OSPF is that by the network x.x.x.x 0.0.0x area x command? i have trunked the interfaces to the routers and have setup all the subinterfaces, i just am confused as ...

teejay1719 · 04-30-2014

All i want is the pcs on either side to have connectivity with different vlans configured for each one, i guess i believe it to be able to see the tagged traffic, detag it, then send it on its way, retag it and then send it to its destination... Is t...

Member Since	‎04-29-2014 08:04 PM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	8

User Statistics

User Activity

IPSLA (Testing Jitter/Delay/Frame-Relay)

Can NAT port forwardign work with HSR

Help with redistributing Vlans Through OSPF

Thank you for your reply, i

I needed it for the PBX to

i have placed the PC ip

thank you for replying again!

All i want is the pcs on