Hello people, I would like to know if there are any limitations on Prime to configure multiple interfaces in order to monitor different segregated networks that do not comunicate with each other. I couldn't find any documentation on this kind of dep...
Hello Community, I'm struggling to configure the LDAPS on the Firepower Manager Chassis to secure the access to the chassis.from the documentation, it seems that I have to enable the SSL on LDAP configuration and then install the CA from the cli as ...
Hello community, We integrated our FMC with the Syslog server to send Intrusion and Security Intelligent event and we can see them coming from the FMC, however, we see also rarely some event from the FTDs as well We didn't enable the FTD logging bec...
Hello Community! We have a Cisco Firepower Management Center and we integrated it with Tenable to send the vulnerabilities to the FMC. we followed the steps for integration from this link https://github.com/QuiLoxx/ATS-APIs/tree/master/firepower/ne...
Hello Community, We have two FTD 2100 in High availability Active/ Standby managed by a virtual Firepower Management Center, I noticed that from the VPN dashboard -> Active VPN Sessions by device shows that a certain number of vpn clients are under ...
Actually, I've tried from the Prime to access SSH to the device and the connection was timed out, and I can reach the device from prime (I can ping it)obviously, from that specific network, we are able to access SSH to the device.I was wondering if t...
Hello Merce1000, Actually, to do so we configured 4 interfaces on Prime, G0 (management of Prime), G1, G2, G3.the Gi0 where the management is configured on Prime and the G1 are working, icmp, SSH, SNMP.on G2 and G3, we were able to reach the devices ...
Hello Moses We have a Cisco Firepower Management Center and we integrated it with Tenable to send the vulnerabilities to the FMC. we followed the steps for integration from this link https://github.com/QuiLoxx/ATS-APIs/tree/master/firepower/neipate...
Amazing!! I was looking for more information about the requirements of the Intersite network:- what are the supported interconnection technologies that used connect the mutli-site: the white paper was showing Dark fiber from 10G to 100GB, ...is it po...
Hi Mike, We are dealing with DNAC version 1.3.0.4 to do Backups. When I try to configure from DNAC GUI or CLI from the master node I face the same result:Linux Repo side:the Linux repository receives the connection from the DNAC but after few seconds...
