I was wondering if someone can give me a hand with troubleshooting an issue I have on my Cisco SG300-10 switch.
Cisco SG300-10 switch in L3 mode
WatchGuard Firewall with x1 interface on 10.0.1.1 DHCP is turned off on WatchGua...
Good Afternoon All,
I'm having difficulties setting up my Cisco SG300 switch with a WatchGuard XTM 26 and was wondering if I could have your assistance.....
Below is my current setup and what I am trying to achieve
Cisco SG300 Switch
Switch in ...
I have a Cisco SG300-10 managed switch with three VLAN's configured
VLAN 10 - Guest network 192.168.10.1 255.255.255.0
VLAN 20 - Home network 192.168.20.1 255.255.255.0
VLAN 24 - Test lab network 192.168.24.1 255.255.255.0
I have ass...
Hi Guys,Wondering if someone could help me,I purchased a Cisco RV110W box a month ago and have finally got round to setting it up but I'm experiencing connection issues and have to reboot the box for it to work again, I'm currently running the latest...
You have just confirmed to me what I have been trying to do all along so I'm glad I was going down the right route.
Are you a Catalyst man? if so please let me know the CLI commands and I'm sure I will be able to work it out?
For example if I set ge1 to "no switchport" and set an IP address on the same range as my Watchguard like 10.0.1.2?
Currently my Watchguard is on 10.0.1.1
I did try assigning a port last night but found no success. Would you be able to provide me the...